After a small drive check the bolt to make sure its still tight if you wish (let the engine warm/cool).
Items Needed Transmission Side Shots – May vary but this is a general idea Pump to Put Fluid back in the transmission Step 1 – Jack up the vehicle / Drive up on some ramps This is a must to gain access to the transmission.If you can get the car level its best, but not a requirement.Commonly used wherever people get online -- including IMing, SMSing, smartphones, Web sites, games, newsgroup postings, in chat rooms, on blogs, or on social media -- these abbreviations are used by people around the world to communicate with each other.Net Lingo is also tracking a global list of worldwide text terms and international online jargon! The truth is its always good to change your transmission fluid for your manual transmission often.
This allows you to check for early wear signs and other issues as well as keep the fluid fresh.Step 6 – Drive the car off the ramps Thats about it, just take it for an easy drive and when you get back check for leaks.Might even be a good idea to let it sit for a bit and check for leaks before you drive it. Step 7 – First time driving after change Listen for any odd noises and take it easy on it for a little bit.Transmission Fill Plug and Drain Plug Location Step 4 – Let it Drain fully Relax for a few and let all that can drain out, you can pump some extra in to do a final flush if you wish.Step 5 – Fill the Transmission with Fluid Put the drain plug back in and snug it down, no need to over tighten. If its new perhaps rinse it out with some extra transmission fluid you have.It is not proper netiquette to TYPE IN ALL CAPS (even in email), in fact, it's annoying.