Updating terastation firmware

Five minutes go by and you think OK this is taking a bit longer than I thought… ”) If you have turned it off, then at least do the points below first and then turn it back on Don’t bother closing the NAS Admin web page this won’t help when you log in …. So do these: In my case the PC was connected to my internet router, after doing items 1 and 2 above, the little cog was still turning on Step 2/6, I disconnected the CAT5 network lead from my router an plugged in to the same hub that the LS220D NAS unit was attached to – BINGO!ten minutes go by and you think well, this really should have progressed a bit… At twenty five minutes the panic really hits, still, we are not going to get too worried but we consider shutting down the NAS…At forty seven minutes visions of owning a data-free black “Brick” swim in your fevered nerve induced panic brain. The update process almost immediately progressed to Step 3/6 (to the sound of the Mormon Tabernacle choir singing “Hallelujah! The whole process then completed in a further 7 minutes.

So in order to keep using this partition do we have to upgrade all the drives with similar capacity?

(I read on a forum where they said you cannot use different capacity hard drives with certain RAID partitions.

Make sure xxth backup task is configured correctly.

(“xx” is backup task number.) The Link Station or Tera Station may be in standby mode. If the backup task still fails, check the status of NAS, network, and backup source or destinations.

You want to make some changes to the setup of your 1 month old Buffalo LS220D NAS unit.

You log on to the Admin page So your NAS tells you there is a Firmware update, you foolishly decide that this is good idea – a real good idea!

is for Europe The Europe download site gives each file an ID number so it doesn’t quite work the same. Formerly, coordinator of AMITPRO and Microsoft Partner Area Lead for 2012-2013.

He also isn't a fan of describing himself in the third person.

(even though you have enough IT experience to know firmware updates are scary and dangerous things, that make sane persons shriek in terror and run out of the building and catch a plane from the nearest airport to ….

Well anywhere the kit does not need a firmware upgrade…) But being an idiot (believe me I AM! You Click OK to start the update, and then you enter the code that is displayed, and off the 6 part process starts.

The main problem I had was actually getting hold of the older firmware.